4
Installation Method of the Product (Replacement from Standard Specification)
4. Remove the tandem step
on the left side
of the motorcycle, and pinch the stay
us-
ing M8 x 1.25 bolt
with the tandem step
to install.
[Note]
For the tightening torque of the tandem step
installation bolt, refer to the service manual
of the motorcycle manufacturer.
Measuring Vehicle Height After Replacing
WARNING
After replacement, the caster angle of the front fork is changed from the
pre-replacement state. If ridden in this condition, it is very dangerous because
the motorcycle behavior may be unstable and the brake performance may
change. Before riding, make sure to tune the motorcycle posture.
Measure similarly before replacement, and adjust the lower metal installation position and the spring
preload to be the same value before replacement. (Refer to page 5.)
CAUTION
When lowering the vehicle height, adjust within the compressed range that
each part of the motorcycle does not interfere with the BFRC
®
lite Kit.
Conduct vehicle height tuning at installation with the spring preload.
If tuning is difficult, contact your nearest dealership that sells SHOWA prod
-
ucts.
Balance Free Rear Cushion lite (BFRC lite)_オーナーズマニュアル_e.indd 4
2016/06/13 19:44:30
