Mark V Model 520
Alignment
Page 4
15.
Recheck the setting by loosening the tilt lock,
moving the table, and then repeating Steps 13
and 14. (Rechecking the settings is very im-
portant!)
SET THE WORKTABLE'S 0° STOP
SET THE WORKTABLE'S 0° STOP
SET THE WORKTABLE'S 0° STOP
SET THE WORKTABLE'S 0° STOP
SET THE WORKTABLE'S 0° STOP
16.
Remove the drill bit and drill chuck from the
spindle.
17.
Loosen the base lock (2). Firmly grasp the way
tubes and lower the headstock into the hori-
zontal position, then engage the head rest.
18.
Loosen the table tilt lock and place the table in
the horizontal "0" position. Retighten the table
tilt lock only enough to allow movement with
firm pressure.
19.
Mount the saw blade on the arbor:
a
. Remove the arbor nut by turning it clock-
wise, as seen in Figure B-59a. Hold the
arbor with the threaded part pointing to
the left.
13.
Set the combination square against the bit and
table, as shown in Figure B-55. The square
should contact the bit along its entire length.
When the table is exactly perpendicular to the
drill bit, lock the table, as seen in Figure B-56.
Figure B-56
Figure B-55
14. Both
90° stops (shown in Figs. B-57 and B-58)
should contact the underside of the table. If
they don't, use a 1/2" wrench to adjust the
stops.
Figure B-59a
Figure B-58
Figure B-57
