Page 13
Alignment
Mark V Model 520
Figure B-104
Figure B-108
Figure B-106
Keps Nuts
Figure B-105
Figure B-107
ALIGN THE EXTENSION
TABLE TUBES
76.
Place the straightedge along the infeed-side
tops of both the worktable and extension
table tubes, as shown in Figure B-104.
77.
If the extension table's tube is not aligned
with the worktable's tube, use a 7/16" wrench
to slightly loosen both keps nuts (248) at-
taching the tube to the extension table. Make
the needed adjustments, then re-tighten the
nuts. See Figure B-105.
78.
Repeat Steps 85 and 86 for the extension
table's tube located on the outfeed-side.
MOUNT THE SAW GUARD
79.
Loosen the accessory mount lock and re-
move the extension table. Loosen the table
height lock and remove the worktable. Place
the saw blade and arbor in the lower saw
guard cover (204).
80.
Fit the lower saw guard's clamp on the
spindle quill (59). Line up the arbor set
screw with the spindle knob's set screw
(where the spindle flat is located). Use a 5/
32" Allen wrench to tighten the arbor set
screw, as shown in Figure B-106.
87.
Use the 5/32" Allen wrench to tighten the
socket head screw (215) on the saw guard
collar, as seen in Figure B-107.
INSTALL THE RIVING KNIFE
82.
Loosen the guard lock knob (210) and insert
the upper saw guard's riving knife (199)
between the guard (213) and the lock plate
(208), as demonstrated in Figure B-108.
