10
GENERAL PARTS KNOWLEDGE
ASSEMBLY
BEVEL SCALE
STAND
ON/OFF
SWITCH
BEVEL
LOCK
HEIGHT
ADJUSTMENT
WHEEL
FENCE RAIL
SCALE
MITER GAUGE
BLADE GUARD
TABLE
RIP FENCE
PUSH STICK
FENCE LOCK
ANTI-KICKBACK PAWLS
THROAT PLATE
RIVING KNIFE
OUTFEED EXTENSION
STAND ASSEMBLY
Assemble stand part 2 (I) through stand part 1 (H) that has
cross support as shown in (FIGURE 1). Secure stand assembly
with M8 x 65mm hex socket head screw (d), M8 spacer (c), M8
washer (b), and M8 lock nut (e). (FIGURE 1)
NOTE:
M8 spacer (c) is between stand part (H) and (I).
(FIGURE 2) for correct stand parts setup.
The part and hardware names and letters correspond to those shown in General Parts Knowledge, Shipping Contents, and the
Hardware Contents.
When lifting saw, hold it close to your body while lifting.
Keep knees bent and lift with your legs, not your back.
Fully assemble saw with stand assembly prior to use. Stand
assembly is an integral and necessary part of the support
structure for this saw. Do not attempt to substitute a table or
other surface for the stand assembly. Do not modify saw, or
create accessories not recommended for use with this saw.
Do not connect to power supply until assembly is complete.
Make sure power switch is in “OFF” position before connecting
to power supply.
Avoid contact with blade teeth. Keep blade stored or lowered
when possible.
FIGURE 1
I
H
d
c
b
e
