Shop-Vac SERIES L, User Manual

Page: 6 / 36

Remove the tank cover by pushing in the side lugs with
thumbs and lifting up on the tabs of the tank cover.
Remove any accessories and literature that may have
been packed in the vacuum tank.
UNPACKING INSTALLATION
MOUNTING THE
WALL BRACKET
GENERAL SET UP
PAGE 5
Questions?
U.S. Customers
call
888-822-4644
or visit
www.shopvac.com
24 hours a day.
Canadian Customers call
905-335-9730
or visit www.shopvac.ca 24 hours a day.
FIGURE 1
6. Select mounting location at a wall stud and /or
provide a surface that is strong enough to hold the
combined weight of the vacuum with a full tank of
debris and accessories.
7. Secure wall bracket to
mounting surface with 2
screws provided or other
suitable fastener.
(
NOTE:
The screws provided
are adequate ONLY for
mounting into wood. Be
sure to use the proper,
suitable fasteners for mounting vacuum to a
surface other than wood.) Be sure wall bracket is
level
FIGURE 2
.
8. Install vacuum by
aligning groove on either
side of tank to engage as
the vacuum is lowered onto
the wall bracket
FIGURE 3
.
9. To avoid possible injury or damage by dislodging
vacuum from wall bracket or dropping tank during
unlatching, always remove the entire vacuum from
wall bracket and set on floor to empty tank or
service filter.
10. Before removing
vacuum from wall bracket,
check to make sure tank
cover is secured to tank. To
remove vacuum from wall
bracket, grasp top handle
with one hand and tank
bottom with other hand. Slide vacuum off of wall
bracket by lifting straight up on vacuum
FIGURE 4
.
1. Before replacing tank cover, refer to Dry Pick
Up or Wet Pick Up Operation in user manual to
ensure you have the proper filters installed for your
cleaning operation.
2. Replace tank cover on the tank by aligning tabs
with the lugs. Press down firmly on the upper
housing until tank cover snaps into place.
3. Insert machine hose
end into inlet of tank.
Twist slightly to tighten the
connection
FIGURE 1
.
4. Attach one of the cleaning accessories
(depending on your cleaning requirements) to the
accessory end of the hose. Twist slightly to tighten
the connection
FIGURE 1.
5. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF
NOTE:
Many more useful tools are available at your
local dealer or the Shop-Vac ® website.
WARNING!
INADEQUATE MOUNTING COULD ALLOW THE
UNIT TO FALL, CAUSING INJURY AND/OR
DAMAGE TO THE UNIT.
FIGURE 2
FIGURE 3
FIGURE 4