Shop fox W1845, Owner'S Manual

Page: 26 / 48

-24-
Model W1845 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
Table.Adjustment
The table on the oscillating edge sander moves both
vertically and horizontally to accommodate various
workpiece shapes and thicknesses. Adjust table height
periodically to reduce spot wear of your sanding belt.
Platen.Angle.Adjustment
The sanding angle of the oscillating edge sander is
variable between 0 and 90 degrees.
To.adjust.platen.angle,.do.these.steps:
1.
Loosen angle adjustment lock handle and tilt sander
until the pointer is aligned with desired angle, as
shown in
Figure.18
.
2.
Tighten angle adjustment lock handle.
. Note: Refer to
Page
.
32
to calibrate the angle scale.
1. Move table lock levers to the loose position, as
illustrated by labels on machine.
2.
Push or pull table until there is a gap of no more
than
1
/
16
" from sanding belt, as shown in Figure.20 .
3. Move table lock levers to the locked position to
secure table position.
Figure 18 . Adjusted sanding angle.
Figure 19 . Height adjustment controls.
Lock Handle
Pointer
Handwheel
Lock
Handles
Figure.20.
Horizontal table adjustment.
Maximum
1
⁄
16
" Gap
Table Lock Levers
Vertically.Adjusting.Table
1.
Loosen the lock handles that secure table height
position.
2..
Turn table height adjustment handwheel
shown in
Figure.19
clockwise to raise table or
counterclockwise to lower table.
3.
When desired position is achieved, tighten the lock
handles to secure table height.
Horizontally.Adjusting.Table