-19-
Model W1845 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
There are two 4" dust-collection ports for the sander
that should be connected to a dust collector. The port
locations are shown in
Figure
11
.
Components.and.Hardware.Needed:.
.Qty
Dust Collector ...................................................1
Dust Hoses 4"
....................................................2
Hose Clamps 4"
..................................................4
Tools.Needed
Phillips Head Screwdriver #2 ..................................1
To.connect.your.machine.to.a.dust-collection.system,.
do.these.steps:
1..
Use 4" diameter hose and clamps to connect a dust-
collection system to your dust ports (see
Figure
11
).
2.
Tug the hose to make sure it does not come off.
.
Note:
A tight fit is necessary for proper
performance.
Recommended.CFM.at.Dust.Port:................. 400.CFM
Dust.Collection
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the dust
port, you must consider these variables: (1) CFM rating of
the dust collector, (2) hose type and length between the
dust collector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines throughout
the system. Explaining how to calculate these variables
is beyond the scope of this manual. Consult an expert or
purchase a good dust collection “how-to” book.
This. machine. creates. substantial.
amounts. of. dust. during. operation..
Breathing. airborne. dust. on. a. regular.
basis.can.result.in.permanent.respira-
tory.illness..Reduce.your.risk.by.wear-
ing.a.respirator.and.capturing.the.dust.
with.a.dust.collection.system.
Figure
11
. W1845 dust ports.
Summary of Contents for W1845
Page 45: ...Model W1845 For Machines Mfd Since 6 17...
Page 48: ......
