-24-
W1761/W1762 12" Table Saw with Riving Knife
SE
T
U
P
ON/OFF Switch
Miter Gauge
To install the miter gauge, do these steps:
1.
Install the miter gauge handle and 8mm flat washer
onto the miter gauge as shown in
Figure 33
.
2.
Slide the miter gauge into the miter gauge slot to
the left of the blade; or store it temporarily on the
brackets near the blade angle handwheel.
To install the switch, do these steps:
1.
Fasten the switch to the left end of the front rail
with two M8-1.25 x 25 flange bolts, and install the
anti-start safety pin as shown in
Figure 32
.
Fence Components
To install the fence knobs, fence, and fence resting
brackets, do these steps:
1.
Install the fence knob as shown in
Figure 34
.
2.
Install the fence onto the table to the right of the
blade.
3.
Check for fence parallelism and adjust if needed.
See
Adjusting Fence
on
Page 53
.
4.
Install the fence resting brackets (
Figure 35
) onto
the back of the cabinet with two flange bolts.
Figure 3
3. Miter gauge installed.
Washer
Handle
Figure 32
. Switch installed.
Figure 34
. Fence knob installed.
Figure 35
. Fence resting brackets
installed.
Brackets
Summary of Contents for W1761
