Shop fox W1761, Owner'S Manual

Page: 33 / 88

-19-
W1761/W1762 12" Table Saw with Riving Knife
SE
T
U
P
5.
While an assistant holds the extension table, fasten
the 93" front rail to the extension table with three
M8-1.25 x 25 flat head screws, flat washers and hex
nuts ( Figure 16 ). Finger tighten for now.
6. Fasten the 79" rear rail to the extension table with
three M8-1.25 x 25 cap screws, lock washers, flat
washers, and hex nuts, as shown in Figure 17 .
Finger tighten for now.
7.
Align the table and extension table with a straight-
edge ( Figure 18 ), then tighten the fasteners in
Figure 16
with a 5mm hex wrench and 13mm
wrench.
8. Repeat the leveling procedure and tighten the fas-
teners in
Figure 17
with a 6mm hex wrench and
13mm wrench.
9. Using a 17mm wrench, tighten the hex bolts shown
in
Figure 15
.
10.
Thread a
3
/
8
-16 hex nut on each foot and thread the
feet into the bottom of the support legs as shown in
Figure 19
.
Figure 16 . Front rail/table fastener
locations.
Figure 17
. Rear rail/table fastener
locations.
Figure 19
. Foot installed on support leg.
Foot
Support Leg
Hex Nut
Figure 18
. Leveling main extension table.