Shop fox W1761, Owner'S Manual

Page: 32 / 88

-18-
W1761/W1762 12" Table Saw with Riving Knife
SE
T
U
P
To install the front and rear rails, do these steps:
1.
Fasten the 93" front rail onto the table saw with five
M8-1.25 x 25 flat head screws as shown in Figure
13
. Secure the flat head screw on the far left with a
flat washer, lock washer, and hex nut.
2. Fasten the 79" rear rail to the table with five M8-
1.25 x 25 cap screws as shown in
Figure 14
. Secure
the cap screw on the far right with a flat washer,
lock nut, and hex nut.
3.
Thread two M10-1.5 x 25 hex bolts with flat wash-
ers onto the right side of the table saw cabinet as
shown in
Figure 15
. Do not fully tighten the bolts.
4.
With the help of an assistant, place the extension
table between the rails and slide the table slots
over the bolts installed in
Step 3
.
Extension Table
Figure 14
. Rear rail installed.
Figure 15 . Hex bolts installed.
Hex Bolts
Figure 13 . Front rail installed.