-25-
Model W1701W (For Machines Mfd. Since 1/16)
O
PE
R
ATIO
NS
To.install.cutters.and.rub.collars,.do.these.steps:
1.
DISCONNECT
MACHINE FROM POWER!
2.
Slide the cutter(s) and rub collars onto the spindle in
the correct orientation for your intended cut.
3.
Install the keyed safety washer and spindle nut (see
Figure.26
).
Figure.26.
Example of placing keyed
safety washer on spindle.
Keyed
Safety
Washer
Figure.27..
Tightening spindle nut.
4.
Thread on and tighten down the spindle nut with the
provided 23mm wrench, while holding the spindle at
the top with an 8mm wrench, as shown in
Figure.27.
5.
Make sure the cutter rotates freely in the correct
direction needed for the cut (in most cases this is
the FWD direction on the FWD/REV switch, which is
counterclockwise on the spindle).
6.
Install applicable safety guard(s).
AMPUTATION/LACERATION.
HAZARD!
Accidental. contact. with. a. cutter.
during.operation.will.remove.parts.
of.fingers.or.large.chunks.of.flesh..
A.safety.guard.greatly.reduces.this.
risk.and.must.always.be.used.when.
operating.this.machine!.
CUTTER.FLY-APART.HAZARD!
Always.use.the.keyed.safety.washer!.The.lock.tang.
on.this.washer.prevents.the.shaper.cutter.bit.from.
loosening.the.spindle.nut.during.operation.
Spindle
Nut
•
Rub collar between two cutters: Using a rub collar
between two cutters offers the distinct advantage of
performing two cuts at once or eliminating the need
to change cutters for two different operations (see
Figure
25
)
. Notice that part of your workpiece edge
remains uncut and rides along the rub collar.
Figure.25..
Rub collar mounted between
two cutters.
Between
Rub
Collar
