Shofu Ceramosonic S, Directions For Use Manual, Page: 25 / 32

7
Notes
• If turning off and restarting the equipment with the
mode set at AUTO, AUTO mode operation can be
continued.
• If vibration in AUTO mode can not be performed
properly, adjust the sensitivity controller to the point
that the platform does not react to the extrinsic vibra-
tion or sound.
• If extrinsic vibration or sound affects the operation, set
sensitivity control lower or choose CONT. mode.
• AUTO mode operation is automatically discontinued
after 60 minutes after setting the mode. Reset to
continue the AUTO mode.
• Vibration pattern or strength may differ when in use.
Adjust the VIBRATION to obtain desirable perfor-
mance.
• When discontinuing the operation, set the switch at
STANDBY.
• Make sure to switch off especially after operating at
AUTO. The machine sound at STANDBY is very soft.
• Do not use continuously when the surface temperature
of the vibrating platform becomes over 55ºC.
• Vibration pattern and strength slightly differs on each
equipment.
• Not all cases can be condensed. Check the condition
for each case.
4. Display
1. When POWER is ON :
Yellow green POWER lamp lights up.
2. While vibrating :
Orange CONDENSE lamp lights up.
3. When malfunctions :
Power lamp blinks in yellow green and red in turn to alarm overheating.
Note
• When using continuously for a long time, a circuit breaker may work to avoid overheating. When it happens, turn off the
POWER switch to cool down the main unit.