Daily Inspection
Inspection of the tank inlet filter
Please remove the fuel cap and check if dirt/
dust sticks to the inlet filter
If there are any dirt/dusts, remove the
filter and wash it with fuel.
Please restore the tank inlet filter, and
tighten firmly the fuel cap.
Inspection of the filter and drainage of water from the fuel tank
Check whether or not the filter element is
dirt and foul.
In case the filter element is dirty or clogged,
please replace it with a new one, and bind firmly
the cup with the tightening ring.
If the dirt or water are found in the cup,
eliminate them. Also, that means there are
dirt or water in the tank as well. Follow the
next instructions and eliminate the dirt or
water from the fuel tank.
Remove the fuel cap, take out the tank inlet
Later on, please remove with wrench the
filter and insert a handy suction pump into
drain bolt and tilt the fuel tank until the
the tank.
fuel is completely drained out of the tank.
(At the same time, be careful not to lose
Remove as much fuel as possible (with
the drain bolt packing)
the handy suction pump).
Restore the drain bolt packing and tighten
Restore the tank inlet filter and tighten
the drain bolt firmly so fuel cannot
firmly the fuel cap.
leak out (of the fuel tank).
Prepare an empty container of about 3 liters
Wipe off kerosene or water spilt over the
(0.7gallons) capacity: to hold kerosene and
tank.
water remaining in the fuel tank, place the
container under the drain bolt (of the fuel
tank).
Checking the filter element
Drainage of water from the fuel tank
1
3
2
1
3
2
1
3
2
4
5
6
7
All manuals and user guides at all-guides.com