37
8.4
Judge by Absolute Values
8.4.1
Set two limit values by putting actual samples on the balance
1 Start the limit function.
Press the Set key for a few seconds.
When the display indicates [
], release the
key.
The current lower limit is displayed next to [LO
].
2 Put the lower limit sample on the balance.
Put the lower limit sample on the pan.
3 Save the lower limit.
Press the Function key.
When a lower limit is saved, the value is displayed for
a while.
* To set only one point, ignore the following steps.
4 Set an upper limit.
The display then indicates [
], and you can
now set an upper limit.
The current upper limit is displayed next to [HI
].
5 Put the upper limit sample on the balance.
Put the upper limit sample on the pan.
6 Save the upper limit.
Press the Function key.
When an upper limit is saved, that value is displayed
for a while. Then the balance goes back into
measurement mode.
* For the case of three or four point setting, repeat the above steps 2 through 3.
Limit values saved are displayed as [
] - [
] or [
] rather
than [
] or [
]. In addition, a triangle [
] on the left side of the display will be
lit at the same time for indicating the setting level.
『
』（第4設定点）
『
』（第3設定点）
『
』（第2設定点）
『
』（第1設定点）
HI
OK
LO
Fourth point
Third point
Second point
First point
Function
Function
Set
Continuous press
