24(41)
3.3.2 Installation of the Flap
Hold the blade rest vertically and put the shaft sleeve on the blade rest shaft in a
balanced way. Then place another proper bolt sleeve on top and press it into with
a hydraulic machine or use a copper stick to softly knock it into. After the shaft
sleeve has been installed, then put the flap onto it. The three countersunk holes
should be aligned to the three M8 holes on blade rest and fill in screw fixation glue
at the holes, then mount the three M8
×
16 inner hexagonal screws and tight them
up.
Picture 3-4: Installation of the Flap
3.3.3 Installation of Bearing Block and Bearing
Clean up scrap iron and impurities from the holes within the bearing block, then
turn the reverse side up and knock the oil seal softly into the bearing block and
daub some lubricating grease. After finishing that, lay the bearing into the bearing
block smoothly with a hydraulic machine or use a copper stick to softly knock it
into.
Picture 3-5: Installation of Bearing Block and Bearing
