Shindaiwa DGW300MS/UKV, Owner'S And Operator'S Manual

Page: 35 / 44

- 30 -
(3)
Cleaning/Replacing the Air Element
Cleaning
1st time: 50th hour /
2nd time and after: Every 100 hours
Replacement Every 400 hours
1)
Release the air cleaner clips and remove the cleaner
cap.
2)
Clean or replace the air element.
<If dry dust is adhering>
Spray compressed air from within the element.
<If carbon or oily substance is adhering>
Replace with a new part.
3)
Install in the reverse order of removal.
<Note>

Clean sooner than scheduled if using the equipment in a
dusty location.

Element part no. : 1G659-11221 (Kubota part no.)
(4)
Cleaning/Replacing the Fuel Strainer
Cleaning
1st time: 50th hour /
2nd time and after: Every 100 hours
Replacement Every 400 hours
1)
Turn the fuel lever to "CLOSE".
2)
Turn the retainer ring counter clockwise and remove
the cup and element.
3)
Remove any water or foreign material from
the cup and clean the element using
compressed air. (Or replace the element.)
4)
Install in the reverse order of removal.
<Note>

Check that no foreign material is adhering to
the packing then install the cup.

After installation, turn the fuel lever to "OPEN"
and check that there is no fuel leakage. After checking, turn the fuel lever to "CLOSE".

Element part no. : 16271-43562(Kubota part no.)
(5)
Draining Water from the Fuel Tank
Draining
Water
Every 200 hours
1)
Remove the fuel drain plug.
2)
Drain the water and tighten the fuel drain plug.
<Note>

Replace the packing with a new part each time you
drain the water.

Packing part no. : 6C090-58961(Kubota part no.)

Always be sure to check that there is no fuel leakage
after tightening the fuel drain plug.
Element
Fuel Drain Plug
Air Cleaner
Clip
Clip
Fuel Strainer
Fuel Lever
Retainer
Ring