Shindaiwa DGW300MS/UK, Operator'S Manual

Page: 28 / 34

- 26 -
(2) Oil Filter Change
①
Drain the engine oil completely, as described in
『
11 (1) Oil Change
』
.
②
Loosen and remove the oil filter, using an oil filter wrench.
③
Smear a little engine oil on the rubber gasket of a new filter.
④
Screw the new filter into place and tighten it by hand until the gasket contact
the seat. Then, give it additional
『
1.1/4 Turn
』
to seat the filter, using an oil
filter wrench.
⑤
Refill with oil and install the filler cap.
<Caution>
If an oil filter wrench is not available, contact with our dealer or authorized
distributor.
Oil Filter Part No.
：
15241-32090 (Kubota)
(3) Clean/Change Air Filter Element
Clean 1
st
50 hours and Every 100 hours afterwards
Replace Every 400 hours
①
Disconnect the Air Cleaner Cap by releasing the clips.
②
Remove the air element.
③
Clean or replace the air element.
<The element is adhered with dried contaminants>
Blow compressed air from inside the element.
<The element is adhered with carbon or oil>
Replace with a new one.
④
Reinstall them in reverse order.
<Caution>
Clean more frequently, if it is used in dusty environment.
Element Part No.
：
1G659-11221 (Kubota)
First Time 50 hour mark
2
nd
or after Every 200 hours
AIR CLEANER CAP
CLIP
AIR CLEANER
ELEMENT
OILFILTER
AIR CLEANER CLIP