Shindaiwa DGA37CM, Owner'S And Operator'S Manual

Page: 40 / 56

36
(1) Change engine oil
Remove the Oil Gauge.
Remove the Oil Drain Plug to drain
engine oil.
Tighten the Oil Drain Plug.
Add oil through Oil Filler to fill it up to the .
MAX level while checking the oil level
on the oil level gauge.
Tighten the Oil Gauge.
< Note >

For the volume and the type of engine oil to use and to replace, refer to
『
8-1. Checking Engine Oil
』
.
(2) Oil Filter Change
Drain the engine oil fully, as described in
(1) CHANGE ENGINE OIL.
Loosen and remove the oil filter, using an oil
filter wrench.
Smear a little engine oil on the rubber
gasket of the new oil filter.
Screw a new filter into place and tighten it
by hand until the gasket contacts the seat.
Then, give it additional 1-1/4 turns, using
an oil filter wrench after the gasket touch
the seal surface.
Supply engine oil.
Initial 50 hours
2
nd
and after Every 200 hours
1
2
3
4
5
Initial 50 hours
2
nd
and after Every 400 hours
1
2
3
5
4
Gasket
Oil Drain Plug
Oil Gauge
Oil Filler
Oil Filter