Shindaiwa dga20e, Owner'S And Operator'S Manual

Page: 39 / 52

37
Oil Drain Lever
Oil Drain Plug
2
Oil Gauge
Oil Filter
Fuel Filter
Oil Drain
Oil Filler (Cap)
(1) Change engine oil
Remove the Oil Filter cap.
Remove the Oil Drain Plug and
then turn the Oil Drain Lever to
OPEN and drain the engine oil.
Turn the Oil Drain Lever to CLOSE and tighten the Oil Drain Plug.
Pour the oil to the upper level, checking
the height with the Oil Gauge.
Tighten the Oil Filler Cap.
<Caution>
For the volume and the type of engine oil to use
and to replace, refer to
ᇹ
8-1. Checking Engine
Oil
ᇺ
.
(2) Oil Filter Change
Drain the engine oil fully, as described
in (1) Change Engine Oil.
Loosen and remove the Oil Filter, using an oil filter wrench.
Smear a little engine oil on the rubber gasket of the new oil filter.
Screw a new filter into place and tighten
it by hand until the gasket contacts the
seat. Then, give it additional 3/4-1 turns,
using an oil filter wrench after the gasket
touch the seal surface.
Supply engine oil.
Initial 50 hours
2
nd
and after Every 200 hours
1
3
4
5
Initial 50 hours
2
nd
and after Every 400 hours
1
2
3
5
4
Gasket