Shindaiwa dga20e, Owner'S And Operator'S Manual

Page: 15 / 52

13
(3) Panel Light
Panel light turns ON to illuminate the panel, when turning the
switch (by the light) to ON.
(1) Starter Switch
1. Stop
When the switch is set to this
position, all power will be off.
The switch must be set to this
position to remove the key.
2. Run / Preheat
The switch must be set to this position during operation.
This position is also used during cold season, to preheat Glow
Plug.
<Caution>
Do not leave the switch to this position, while the engine is stopped. Otherwise
the battery is discharged.
3. Start
This position is to start the engine. When the key is released,
the setting will automatically return to <Operating / Preheating> position.
(2) Emergency Stop Button
This button is used to stop the engine in emergency.
By inserting the button, the engine stops.
Be sure to restore the starter switch to STOP and re-set
the button, turning clockwise after using the emergency stop
button.
(3) Main Circuit Breaker
By turning this circuit breaker on the control panel to ON,
Power will be transferred to the output receptacles and to the
load side.
The breaker trips to OFF, either overload or short-circuit.
Switchs
STOP
RUN
PREHEAT
START