Shindaiwa dga20e, Owner'S And Operator'S Manual

Page: 12 / 52

10
(2) Oil Pressure Monitor Lamp (Low Oil Pressure)
Danger : Injuries
Close all doors and place during operating this equipment, to avoid
injuries by unintentionally touching cooling fan and fan belt.
Caution: Burns
Do not touch the engine and muffler during operation and
immediately after stopping the equipment, for the temperature can
reach extremely high.
Do not open the radiator cap while operating this equipment or
immediately after stopping the equipment, to avoid sustaining burns
from hot vapor.
When checking engine oil or changing oil, always stop the engine,
and wait until the engine cools down. If you open either the oil gauge
or the oil plug during operation, hot oil may cause some injury.
When the engine oil pressure drops below 0.98 x 100kPa {1kgf/cm
2
}
during operation, the oil pressure monitor lamp will flash, and the
automatic shutdown will be engaged.
When this occurs, check the engine oil level, and replenish to the
maximum level if needed.
<Caution>
The engine oil pressure monitor cannot detect the degradation of engine oil
itself. Please check the engine oil periodically, and change if needed.
(Refer to
ᇹ
8-1. Checking engine oil
ᇺ
)
(3) Battery Charge Monitor Lamp (Charging Lamp)
When the battery turns unable to be charged during operation, the
battery charge monitor lamp will flash. In the event this occurs, stop
the engine consult with the authorized distributor or our
engineering section.
<Caution>
The battery charge monitor cannot detect the degradation of the battery
nor the battery fluid level. Check the battery fluid level periodically.
(Refer to
ᇹ
8-6. Checking Battery
ᇺ
)
㻌
OIL PRESS
CHARGE