Shindaiwa C225S, Operator'S Manual

Page: 24 / 188

22
Before you start
Installation of shield
Fit shield to mounting portion of angle transmission and tighten 4
bolts.
Installing blade
Inspect blades before installation. Check for sharpness.
Dull blades increase the risk of blade kickback reactions.
Small cracks can develop into fractures resulting in a piece of
blade flying off during operation.
Discard cracked blades no matter how small the crack.
Blade retainer, blade, lower blade retainer, cup and nut finger
tight.
1. Wire end
2. Nuts 3. Carburettor
CAUTION
After assembly, adjust the play of wire end on carburettor
side to 1 mm - 2 mm.
1. Shield 2. Bolt
1. Blade retainer fixing slot
2. Blade retainer
3. Blade 4. Lower blade retainer
5. Cup
6. Nut
DANGER
If worn nut and cup for blade are used, there is a danger of
blade getting loose. Replace them with new one.
WARNING
 Do not attempt to fit the trimmer blade with one hand or
without using the socket spanner. Fit the trimmer blade
accurately using the supplied socket spanner and tight-
en firmly in position.
 The trimmer must not be used if the blade vibrates or is
loose.
 Wear heavy duty gloves when working with the trimmer
blade. When replacing the trimmer blade during a trim-
ming task, ensure that the engine is switched off and
that the blades have stopped.
 Do not use any tools other than the proved socket span-
ner to tighten the blade, a pneumatic or electric tool
may tighten the blade more than necessary and cause
the nut or the output shaft to break.

When turning the product over to replace the trimmer
blade, ensure that the fuel tank cap is securely in place.
‹ Failure to do so could lead to an injury or serious accident,
or cause a fire.