22
2 Others
1 About controller
2 Other
Troubleshooting
7
Contents to confirm
Countermeasure
(1) Make sure if the power (breaker)
is on or off.
Switch the power (breaker) on if
it is off.
In the event that the power (breaker)
shuts down.
Make sure that the power cord
reaches to the kiln itself.
The display shows an electrical leak.
Do trial operation (dry operation).
In the event that the power (breaker)
shuts down not because of an electrical
leak, but because of an electrical short
Contact of hot wires may be
one of the reasons. Repair
is necessary. Please consult
“SHIMPO” ceramics department.
(2)
Confirm if the connection of hot wires is correct or not.
Problems
Countermeasures
The buzzer sounds even
if you do
not set it.
Confirm if the buzzer setting which you
set last time does not remain.
※
If you set buzzers in the process of holding,
the buzzer is responding to the change in the
temperature.
In continuing program, buzzer settings
do affect even when you use other
programs.
If buzzer settings are unnecessary,
please set “No buzzers (AL-0)”.
Please be sure to
read
『
Before Firing
』
before firing.
Please be sure by
『
Electric works
』
About Buzzer
P.12
P.8
P.21
Display panel does not light up.
Buzzers do not sound
Blackout
Please consult “SHIMPO” ceramics department when the above countermeasures
are not effective.
If power supply is restored within 10 minutes : Firing continues in the process as before blackout.
If blackout takes more than 10 minutes : Firing automatically stops.
