21
Assembly of the INTER-8 coaster hub
NOTE:
During the assembly procedures
coat all seals, gears and pawl
assemblies with a thin coat of
Nexus specific grease. Where
indicated by blue grease icon,
apply grease liberally.
3.
Assemble the driver unit by
aligning the more shallow
notch on the driver unit
with the wider tooth on the
clutch unit. Rotate the driver
counterclockwise to hold the
compressed spring in position.
2.
Install the return spring with
the largest coil downward.
The spring should sit in the
groove on the clutch unit,
shown as a blue line in the
picture. Be careful not to
install the return spring A
upside down.
Set drive unit
while turn it
counterclock-
wise.
Clutch unit
(Y-34R 98050)
Clutch unit
(Y-35P 98060)
Return spring A
(Y-34R 21000)
NOTE:
Assemble the driver
unit while pushing
pawls B as shown in
the picture.
1.
With the hub axle unit mount-
ed in a vice, align the two
teeth on the clutch unit with
the two notches in the hub
axle unit. Turn the clutch unit
clockwise until it is in its final
position as shown.
(Y-041020800)
Lay_INTER-8_GB 05 23.12.qxd 23.12.2004 13:39 Uhr Seite 21
