14
Installation of the hub to the frame
1.
Mount the chain on the sprocket, and then set the hub axle into the
dropouts.
Hub axle
Dropout
2.
Place the non-turn washers onto the right side and left side of the
hub axle. At this time, turn the cassette joint so that the projecting
parts of the non-turn washers fit into the grooves of the dropouts.
If this is done, the cassette joint can be installed so that it is almost
parallel to the chainstay.
Non-turn washer (for left side)
Chainstay
Groove of dropout
Non-turn washer
(for right side)
Cassette joint
•
Use whichever non-turn washers match the shape
of the dropouts. Different non-turn washers are
used at the left and right sides.
Dropouts
Non-turn washer
Mark / Color
Size
Right
Left
Standard
5R / Yellow
5L / Brown
ϴ
≤ 20°
7R / Black
7L / Gray
20° ≤
ϴ
≤ 38°
Reversed
6R / Silver
6L / White
ϴ
= 0°
Reversed
(full chain case)
5R / Yellow
5L / Brown
ϴ
= 0°
Vertical
8R / Blue
8L / Green
ϴ
= 60° – 90°
Note:
Vertical: Excluding the coaster specifications.
•
The projecting parts should be on the dropouts side.
•
Install the non-turn washers so that the projecting parts is
securely in the dropouts grooves on either side of the hub axle.
Mark
ϴ
Note:
When installing a part such as a mudguard stay to the hub axle,
install in the order shown in the illustration below.
Non-turn washer
Washer
Cap nut
Mudguard stay
Carrier stay
