Shimadzu BL2200H, Instruction Manual

Page: 24 / 38

-16-
10. PCS (No. of pieces) SETTING
This balance can perform No. of pieces measurement (unit PCS).
No. of standard pieces is 10 pcs, 20 pcs, 50 pcs, or 100 pcs. When the No. of pieces is
increased, the accuracy is improved.
Step (1) Register the PCS unit following the unit
registration. (Refer to “8. Registration,
cancel, and change of unit”.
When PCS unit has been already
registered, it is not necessary to register
again.
(2) Place the tare on the pan and press the
TARE key.
(3) Load the standard sample with required
pieces.
(4) Check that the stability mark is lit.
(5) When pressing the UNIT key
continuously, the display will change as
follows:
“ ”, “ ”,
“ ”, and “ ”
(6) Select the desired PCS display and press the TARE key.
(7) “ ” is displayed for several seconds and the balance enters
the PCS unit display.
When the reference sample weight is less than “readability x No.
of set pieces”, the PCS setting is not made.
In this case, “ ” is displayed for several seconds and
the balance returns to weight display.