15
13) Examine the unit from the top, align the center of the magnet ASSY (U9) and of the force coil ASSY (L1),
and then tighten the force coil ASSY (L1).
Fig. 2-31
14) Slide the four magnet lids (U16) horizontally to mount, and use the pan head screw M2.5 × 5 (4 screws) to
tighten.
15) Insert the gap setting shim (J3) into the space between the upper edge of the lever ASSY (U7) and the
stopper lever (U15) to obtain positioning, and use the screw P3 M3 × 8 (2 screws) to tighten the stopper
lever (U15).
Fig. 2-32
16) Solder the two Pt-Ni bands (U17) to the lever ASSY (U7) side.
* When soldering, apply the solder tilted and upward facing to ensure that the Pt-Ni band (U17)
does not come into contact with the lever ASSY (U7).
17) See 2.3.9 to remove the detector ASSY (U11).
18) Extract the lever fixing pin (J1) from the unit ASSY (1), shake the unit ASSY (1) lightly to move the lever
ASSY (U7) up and down, and if it contacts the stopper lever (U15) with a clear sound, the unit ASSY (1)
assembly is complete.
* If it does not make a clear sound, the lever ASSY (U7) pin and stopper plate (U14), or the force
coil ASSY (L1) and magnet ASSY (U9), may be in contact. Check each part to see if any are out of
position, and readjust the position.
19) Use the procedures in 2.3.8 in reverse to mount the unit ASSY (1) to the base ASSY (B1).
* Always insert the lever fixing pin (J1) before mounting the unit ASSY (1) to the base ASSY (B1).
20) With the stopper plate (U14) in a position aligned to the center of the force coil ASSY (L1) pin, use the pan
head screw M3 × 6 (2 screws) and flat washer M3 (2 locations) to tighten.
Fig. 2-33
21) Perform "4.2 Adjusting the Tilt Error," "4.3 Adjusting the Balance," and "4.4 Adjusting the Cornerload Error."
Align the center.
Gap setting shim
Pin
Stopper plate
