67
1
3
5
2
4
6
7
8
12
14
13
9
10
11
66
Settings
Settings
2.
Set the unit
(1) Select the unit to be registered, and then press
[
OK].
(2) Select [on] or [off], and then press [
OK].
(3) Repeat steps (1) and (2) to set all required units.
3.
Return to the weight measurement mode
Press [
POWER]
User-Specified Unit (Conversion Factor) Settings
It is possible to set a user-specified value (multiplier) to be calculated against the weighing value (g).
1.
Press [
UP] for three or more consecutive seconds while in the
weight measurement mode
Select [Unit setting], and then press [
OK].
2.
Set the user-specified unit to ON or OFF
(1) Select [User], and then press [
OK].
(2) Select [on] or [off], and then press [
OK].
· Proceed to Step 3 if [on] was selected.
· Proceed to Step 4 if [off] was selected.
3.
Set the conversion coefficient
(1) Select [Setting] and then press [
OK].
(2) Select [Conversion coefficient] and then press [
OK].
Enter conversion coefficient within a maximum of 8 digits, and then press [
OK].
[Entering Numerals and Characters] (P.43)
Conversion coefficient Equations
The following equation is achieved if the conversion coefficient is set at [k].
[k] x g unit = Balance weighing value (user-specified unit)
Accuracy When User Units are Set
There are cases in which a value that exceeds weighing capacity is displayed if the user enters
10 as the conversion coefficient for the user unit, for example, so note that the accuracy of
these values cannot be guaranteed.
*
*
