Section 9 Periodical inspections and service
55
Changing the oil
Drain the oil from the rear axle center, and right
and left drain plugs under the rear axle. After
draining the oil completely, tighten the drain
plug, and supply new oil from the oil filler port
on the left above the rear axle and right and left
sides.
6. Replacing the elements
①
Engine oil element
The element is of the cartridge type. Replace
the element after 50 hours of operation first,
and then every 200 hours thereafter.
Changing the oil
(1) After draining the engine oil, turn the
cartridge clockwise and remove it with a
filter wrench.
(2) Coat the rubber ring at the bottom of the
new cartridge with a small amount of oil and
install it positively by hand.
(3) After changing the engine oil, start the
engine and keep to run until the hydraulic
pilot lamp goes out.
(4) After the hydraulic pilot lamp goes out, stop
the engine, check the oil level again with
the dipstick gauge and replenish if not
enough.
Shibaura Europe BV
All manuals and user guides at all-guides.com
all-guides.com
