Sherpa SX-MD16E, User Manual

Page: 7 / 14

1. Voltmeter (Fig. 3)
The Sprayer is equipped with voltmeter measuring voltage
between 11V~15V. The green
area of color scale indicates
full battery , fit for normal
operation
；
Yellow area
indicates low voltage but the
system can still keep working for a limited time; The red area
on the left indicates extremely low power requiring immediate
recharging. The lowest working voltage of the Sprayer is DC
11.5v. The alarm will sound to remind the Operator to stop use
and charge the battery when the voltage falls below this value.
The charger should be only be operated indoors in a dry,
ventilated location 50cm above the ground.
If the Sprayer has been only used for a short time, it is
unnecessary to charge if it is to be used again within 1 week. If
the Sprayer not required for a long time, it should be fully
charged and left on trickle charge connected to mains power, or
charged at intervals (such as one month) in a bid to maintain
the capacity and service life of the battery.
Filling tank with chemical. Remove the lid on top of
sprayer to fill the tank (Fig. 4)
with mixed chemical through the strainer
provided slowly, then tighten the tank lid
carefully.
*Never immerse Sprayer in water for filling or cleaning*
4. Spraying
Ensure the trigger is in the off position! Turn on the power
switch (“-“indicates ON, “O” indicates
OFF). Point the nozzle to the required
area and hold down the trigger bar to
start spraying. (Ensure the work area is
clear of people and animals first.)
Fig. 5
Fig. 3
Fig. 4