Sherpa SX-MD16E, User Manual

Page: 6 / 14

The preparation of chemicals should follow
the instructions and formula published by the
chemical manufacturer. Unauthorized altering
of the dilution rate of chemical is prohibited,
and may endanger human and animal health,
or result in the failure of sprayer or pest
control.
Upon completing the operation, it is
recommended you change your clothes and
wash exposed body parts such as hands and
face. In case of highly toxic pesticides and
germicide, its recommended to shower after
operation to ensure safety.
V. How to Charge the Sprayer
A 48hr first commission charge is required!
The Battery fitted to this product requires a special extended 48hr
charging period before it is used for the first time. This procedure is
required to initialise the battery after shipping.
1. Ensure the Red Switch is in the OFF position (as shown).
2. Connect the mains charger lead. (as shown).
3. Turn Mains Power on and leave for a minimum of 48 hours or
longer.
4. The LED on the charger may remain Green for approximately 40
hours.
5. The LED on the charger will turn Red for the final 8 hours of
charging.
6. The LED Turns back to Green to indicate the charging is complete.
NOTES:
1. The needle meter will not move during the charging period. The
needle meter will only move when the product is in operation: it
shows the remaining power left in the battery when in use.
It is not
an indication of charging progress.
2. When in regular use the charge time will be approximately 8 hours.
3. Do not leave the charger connected to the sprayer with the power
switched off at Mains.
4. We recommend continuous charging when not in use.
Never switch off the mains power supply leaving the
charger connected to the sprayer!
Fig. 1