SHERCO ST 125, Workshop Manual

Page: 11 / 51

9
ST SERIES
CYCLE PARTS
1.3 Disassembly of the fork and replacement of the bearings
•
Remove the two M8 screws
[1]
and
remove the caliper.
Caliper screws : 24 Nm
•
Check the thickness of the brake pads.
Tolerated limit : 1mm
•
Loosen the 4 M8 screws of the
handlebar holder then remove the
handlebars.
•
Loosen the steering column nut [2], the
M8 screws [3] of the upper triple clamp
then remove it.
•
Triple clamp screw : 24 Nm
•
Loosen the steering column lock nut [4] and its dust cover, then separate the complete
Fork of the frame
•
Replace the bearings located in the upper part of the frame and on the part lower of the steering
column
[5]
by brand new reference C009 taking care of grease them.
•
When reassembling, install the steering column lock nut and tighten it so that that the fork turns
freely and without hard point. Then place the top triple clamp and tighten the upper steering
column nut to
20 Nm .
2
1
2
1
3
4
5