11
REMOVING/INSTALLING THE ENGINE
❱❘
Removing the engine
-
Drain (See the owner’s manual)
• The engine oil
• The engine coolant
- Remove the seat.
- Disconnect the battery.
- Remove the fuel tank with its valves.
- Disconnect all of the wiring harnesses that are connected to the engine (starter, etc.).
-
Remove the exhaust (See the owner’s manual).
- Remove the carburetor.
- Remove the chain (use the master link).
- Remove the chain guard.
- Remove the clutch slave cylinder.
- Remove the water lines connected to the engine.
- Remove the left radiator.
- Loosen all of the engine mounting bolts.
- Loosen the swing arm axle bolt.
- Remove the mounting brackets that are attached to the cylinder head and the electric motor.
- Remove the rear axle.
- Remove the swing arm axle.
- Disconnect all of the cables from the valve block.
- Remove the motor.
CAUTION
When the clutch slave cylinder is removed the piston is no longer contained. Retain the piston with a plastic tie.
CAUTION
In order to remove the engine, the swing arm pivot bolt must be removed. This allows the swing arm and the rear
wheel assembly to be separated from the bike. To insure that the bike does not fall, support it with a jack.
Summary of Contents for 250 SE-R 2017
