250-300 SE-R
14
REMOVING/INSTALLING THE ENGINE
- Tighten by 1 full turn the 8 nut (1full turn =
1mm).
- The measurement between the tensioning
cable crimping sleeve and bottom of the
cylinder sheath should be 0.5mm minimum,
1mm
maximum
when
pulling
(WITH
STRENGTH) on the cable to the rear of the
bike. If this measurement is not correct, correct
by thightening or loosening the 8 nut.
- Tighten the 10 nut.
- Lubricate, with grease for chain (in spray), the
cables on the pulley, the pulley groove and the
steel plate to prevent oxidation.
- Replace the protective rubber of the pulley, the
protective plastic cover and tighten the screw.
Finally, replace the protective rubbers on the
two tensioners.
Summary of Contents for 250 SE-R 2017
