SHERCO 125 SE-R 2017, Workshop Manual

Page: 39 / 49

39
ENGINE REASSEMBLY
❱❘ Ignition assembly and its lid
- Place the half-moon wedge in its housing on the connecting rod assembly.
- Insert the rotor on the connecting rod assembly.
- Apply blue brake fluid on the threading.
- Insert tool 1815, install the nut and tighten to 80 N-m.
- Set up the 2 centring bushings.
- Introduce a new joint and fasten the ignition cover.
❱❘ Assembly of the electric starter
- Replace the O-ring on the starter by a new joint.
- Apply a bit of lubricant on the O-ring.
- Insert the starter into the right-hand casing.
- Fasten the starter with the 2 hex sprocket screws.
- Finish the step by oiling and then inserting the clutch control rod into the main shaft [1].
- Assemble the speed selector with its screw and washer.
- Assemble the two drainage plugs with a new joint.
CAUTION
The transmission gearbox needs to be filled when the engine is returned to its frame; otherwise, a portion of the
oil will leak from the main shaft.
1