(2014-07-01)
- 76 -
Parameter
Details
Option
Format1: A.B.C.D/Mask
Port
The network interface of QOS
Value area: 1-65535
You can not configure the port,
if not the configuration
represents all ports
Rate
Transmission rate of the network
address settings
Value area
：
1
～
65535 Units
：
Kbps
Ceil Rate
In ensuring the basic rate and the spare
bandwidth, the maximum bandwidth of
the network address of the
communication can be obtained with
higher priority will be given priority
redundant bandwidth
Value area
：
1
～
65535 Units
：
Kbps
Priority
Set the precedence of the rules
Value area
：
[1,30]
Step 4
Single click “save” icon to QOS setting.
QOS is mainly for the average of user priority assigned route or a bandwidth of Internet users. If the router is
connected with two subnets: 192.168.15.1/24 and 192.168.9.1/24, the router QOS can control the rate of these
two subnets; If the router's bandwidth is relatively well-off, the router can be based on two subnets redundant
bandwidth is first priority and high priority redundancy to meet the bandwidth, then meet low priority subnet
redundancy bandwidth.
---END
5.5.5
Dynamic Routing(Optional)
RIP configuration
RIP protocol (Routing Information Protocol) is the most widely IGP (Interior Gateway
Protocol) , it was designed for the same technology used in small networks, and therefore
adapt to most of the campus network and used in a continuous regional networks that the rate
change is not big, H8959-4GSPT Cellular router supports RIP v2 protocol. For more
complex environments, generally do not use the RIP protocol. RIP business is based on
whether the user needs the RIP at the factory H8959-4GSPT Cellular router .
Step 1
Log-on WEB GUI of H8959-4GSPT Cellular router .
Step 2
Click “Forward > RIP” to open “RIP” tab, as Figure 5-53.
