34
over, causing serious injury or even
death
.
3.
On hydraulic tilt Post Drivers, tighten the nut
on cylinder Scissor Stop bolt (see arrow
below) to prevent the cylinder from drifting
and causing an unstable condition with the
Post Driver.
Cylinder Scissor Stop Bolt.
NOTE:
Failure to tighten this bolt could
allow the Post Driver to fall over, causing
serious injury or even death.
4.
Make sure all pressure is r e l e a s e d (zero
pressure) from the Post Driver hydraulic
system. Disconnect hydraulic pressure
supply hose
(A)
from the tractor or skid
loader
.
Disconnect hydraulic return hose
(B)
from the tractor or skid loader, see below.
Hydraulic Pressure Supply Hose (A), Hydraulic Return
Hose (B), Top Link Pin (C), and Lower Lift Arms (D).
5.
For 3-Point Hitch remove top link pin
(C)
from weldment and disconnect top link.
Then disconnect the two tractor lower lift
arms from the lower hitch pins
(D)
to
separate the tractor three-point hitch from
the Post Driver, see above.
6.
Carefully move the tractor or power source
away from the Post Driver.
Service Procedures
To avoid personal injury or death, carefully
read and understand all instructions before
attempting to assemble and/or operate the
P o s t Driver. Do not operate or work
on equipment unless you read and
understand the instructions and
warnings in this and all other
applicable
manuals.
Contact
Shaver Manufacturing Company if any of the
instructions provided are unclear or not
understood.
Proper
care
is
your
responsibility. Always follow all State and
Federal health and safety laws and/or local
regulations.
To help prevent personal
injury,
protective
equipment must be worn
during
Post
Driver
assembly, operation, and
maintenance.
Personal
protective
equipment
should include, but n o t
b e
limited
to,
safety
glasses,
hearing
protection,
protective
gloves, and steel toe footwear.
Before
making
any
adjustments on the Post
Driver, ensure that all
hydraulic levers are in the
neutral position. Always
shut off the machine, set parking brake, and
remove key before performing any service.
Personal injury can result
from slips or falls. DO NOT
leave tools or parts lying
around the work area and
clean up all spilled fluids
immediately.
NOTE
:
Disassembly,
assembly,
and/or
A
B
D
D
C
WARNING
