21
hose is screwed into the 90° fitting from the
‘OUT’
port of the valve using paste-type
thread sealant on the fittings.
8.
Attach the tilt cylinder hoses as follows (see
chart & illustration on the left). Attach the
other end of the hose connected to the rod
end of the side tilt cylinder (item 6a) to the
45° fitting from the
‘D’
port of the valve using
paste-type thread sealant on the fitting. Then
attach the other end of the hose connected
to the base end of the side tilt cylinder (item
6b) to the 45° fitting from the
‘C’
port of the
valve using paste-type thread sealant on the
fitting. Do the same with the forward tilt
cylinder hoses. The rod end hose (item 6c)
goes to the 45° fitting from the
‘F’
port of the
valve and the base end hose (item 6d) goes
to the 45° fitting from the
‘E’
port of the valve.
IMPORTANT NOTICE
If the tilt cylinder hoses are attached
differently than shown, the control of the
drive ram will not be as described in this
manual.
NOTE: Make sure all hose fittings are tight .
9.
For the other end of the return hose use the
appropriate adaptor listed for your tractor in
the
TRACTOR LISTING
spread sheet.
Return line and adaptor (SM-10-R Adaptor is shown).
10.
For a skid steer/loader with a case drain, use
the Skid Loader Hydraulic Splitter Return Kit
(P/N
SM-SL-HSRK
). To attach it to the Driver,
use pipe thread sealant to screw the Driver Return
Hose into the open port (#3) on the valve. Attach
the Male Quick Coupler using pipe thread sealant
to the pressure hose that goes to the driver valve.
Then plug the quick couplers into the skid
steer/loader ports as called out below.
Skid Loader Hydraulic Splitter Return Kit (above).
IMPORTANT: For the Driver to function
properly the return line must be connected
directly to the hydraulic reservoir of the tractor
or skid steer.
Rubber Debris Guard
1.
Locate rubber debris guard and bag
containing hardware and caution tag.
HD-8/10/12 Rubber Debris Guard mounting (HD-10 shown).
2.
For HD-8/10/12 attach the Rubber Guard and
Caution Tag on drive ram, with guard
mounting hardware, three (3) 1/4-20 x 1
”
Carriage Bolts, Lock Washers, and Nuts, as
shown above.
