16
Hydraulic Tilt Base Control Valve hoses.
6.
Attach the other ends of the hoses as
follows (see above). Screw in one end of the
3/4 x 48” hose (item 5) to the 45° fitting in
the
‘A’
working port on top of the valve
using paste-type thread sealant on the
fittings. The 1/2 x 120 hose (item 3)
connects to the 90° fitting in the
‘P’
pressure
port on the top of the valve using paste-type
thread sealant on the fittings and the other
end is hooked up to the pressure hydraulic
line from tractor. The 3/4" x 120 hose is
screwed into the 90° fitting from the
‘T’
port
of the valve using paste-type thread sealant
on the fittings.
7.
Attach the tilt cylinder hoses as follows (see
chart & illustration on the left). Attach the
other end of the hose connected to the rod
end of the side tilt cylinder (item 6a) to the
90° fitting from the
‘A1’
port of the valve
using paste-type thread sealant on the
fitting. Then attach the other end of the hose
connected to the base end of the side tilt
cylinder (item 6b) to the 90° fitting from the
‘B1’
port of the valve using paste-type
thread sealant on the fitting. Do the same
with the forward tilt cylinder hoses. The rod
end hose (item 6c) goes to the 45° fitting
from the
‘A2’
port of the valve and the base
end hose (item 6d) goes to the 45° fitting
from the
‘B2’
port of the valve.
IMPORTANT NOTICE
If the tilt cylinder hoses are attached
differently than shown, the control of the
drive ram will not be as described in this
manual.
NOTE: Make sure all hose fittings are tight .
8.
For the other end of the return hose use
the appropriate adaptor listed for you tractor
in the
TRACTOR LISTING
spread sheet.
Return line and adaptor (SM-10-R Adaptor is shown).
IMPORTANT: For the Driver to function
properly the return line must be connected
directly to the hydraulic reservoir of the
tractor or skid steer.
Note:
Tilt Cylinder Levers on the valve can be
repositioned from their normal vertical to a
horizontal position. To reposition the levers,
loosen the jam nut on the lever and
unscrewing the lever. Move the lever to the
horizontal location and screw the lever in and
then tighten the jam nut.
Tilt Levers alternate position on Control Valve (arrows
above).
Hydraulic Hose Chart
Item
Valve Port
Location
3
P
Pressure Hose
4
T
Return Hose
5
A3
Driver Cylinder
6a
A1
Side Tilt Cylinder Rod End
6b
B1
Side Tilt Cylinder Base End
6c
A2
Forward Tilt Cylinder Rod End
6d
B2
Forward Tilt Cylinder Base End
5
4
3
6a
6b
6c
6d
