14
The
Main
Carriage
Channel
Assembly is tall and heavy. To
avoid tip over, resulting in serious
injury or death, leave the overhead
lifting device attached to the Main
Carriage
Channel
while
assembling components.
Proper lifting device (large arrow above) when attaching
Driver to Base Plate
.
Attaching the Driver to Base Plate.
a.
Position and align Driver with lower base
plate pivot location
(A above).
Install the pin
and secure with included cotter pins.
b.
Manually extend Forward Tilt Cylinder, align
and install upper mounting pin
(B above)
and scissor stop safety lever
(C above)
.
Make sure scissor stop safety lever
(C
above)
is installed on upper mounting pin
(B above)
. Secure with included cotter pins.
Connection to Hydraulic Supply
The customer must supply suitable hydraulic
quick disconnect fitting for connecting pressure
supply hose. For return hose to the tractor or
power supply hydraulic system, use the
appropriate adaptor listed for you tractor in the
TRACTOR LISTING
spread sheet, see your
dealer or distributor.
Hydraulic Valve & Hose Installation
IMPORTANT NOTICE
Hydraulic system fittings that require a
thread sealant must be installed with a paste-
type sealer only. Do not use a tape-type
sealer, such as Teflon Tape, as this can
contaminate the system and voids the valve
warranty.
IMPORTANT NOTICE
The hydraulic valve and cylinder(s) can be
damaged by contamination (dirt and debris)
from the oil in the tractor or power source.
Ensure the oil is clean and properly filtered
before connecting the Post Driver to a
hydraulic power source. Failure to follow oil
cleanliness standards voids the Shaver
Post Driver warranty.
A
B
C
