-16
Setup & Connections
Power ON/OFF
Press
POWER ON
.
• The blinking green LAMP REPLACEMENT indicator
shows that the lamp is warming up. Wait until the
indicator stops blinking before operating the projector.
• If the power is turned off and then immediately turned
on again, it may take a short while before the lamp
turns on.
• After the projector is unpacked and turned on for the first
time, a slight odor may be emitted from the exhaust
ventilative hole. This odor will soon disappear with use.
When the power is on, the LAMP REPLACEMENT
indicator illuminates, indicating the status of the
lamp.
Green:
Lamp is ready.
Green blinking:
Warming up. / Cooling down.
Red:
Change the lamp.
Press
POWER OFF
.
• Press
POWER OFF
again while the confirmation
message is displayed. Then, message “Terminating.
Please wait.” will appear.
• If you accidentally pressed
POWER OFF
and do not want
to turn off the power, wait until the confirmation message
disappears.
• When
POWER OFF
is pressed twice, the POWER indicator
will illuminate in red and the cooling fan will run for about
90 seconds. The projector will then enter standby mode.
• Wait until the cooling fan stops running before disconnecting
the power cord.
• The power can be turned on again by pressing
POWER
ON
. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicators illuminate in
green.
TEMP.
LAMP
POWER
POWER (ON/OFF)
buttons
Zooming and Focusing
The picture can be zoomed in or out, and focused by the Zoom knob and the Focus ring.
1
Slide the Zoom knob. The image can be adjusted
to the desired size within the zoom range.
2
Rotate the Focus ring until the image on the screen
becomes clear.
1
2
A dimly lit screen is displayed for a short time
(about 20 seconds) to reduce lamp damage.
