Basic Operation
-37
Turning the Projector On/Off
Info
•
If “Direct Power On” is set to “ON”, the projector will
be turned on automatically when you plug the power
cord into the AC outlet. (See page
•
English is the factory preset language. If you want to
change the on-screen display to another language,
change the language according to the procedure on
page
▼
On-screen Display
Info
•
You can unplug the power cord even if the projector is op-
erating.
•
Even if you unplug the power cord from the projector, the
cooling fan continues to run for a while.
Power cord
Supplied
accessory
Connecting the Power Cord
Plug the supplied power cord into the
AC socket on the rear of the projector.
Then plug into the AC outlet.
Turning the Projector On
Before performing the steps in this section,
connect any equipment that you use with the
projector. (See pages
Remove the lens cap and press
on the
projector or
on the remote control.
•
The power indicator illuminates green.
•
After the lamp indicator illuminates, the projec-
tor is ready to start operation.
•
When System Lock is set, the keycode input
screen appears. Enter the right keycode to
start projection. See page
for details.
Note
•
The lamp indicator illuminates or blinks, in-
dicating the status of the lamp.
Green:
The lamp is on.
Blinking green:
The lamp is warming up.
Red: The lamp is shut down abnor-
mally or the lamp should be
replaced.
•
When switching on the projector, a slight flicker-
ing of the image may be experienced within the
first minute after the lamp has been illuminated.
This is normal operation as the lamp’s control
circuitry is stabilizing the lamp output charac-
teristics. This does not indicate malfunction.
•
If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to illuminate.
Turning the Power Off
(Put-
ting the Projector into Standby Mode)
1
Press
on the projector or
on the remote control, then
press that button again while the
confirmation message is dis-
played, to put the projector into
standby mode.
Power cord
To AC outlet
Side view
To AC socket
Lamp indicators 1, 2
Power indicator
STANDBY
button
ON button
Lens cap
ON button
STANDBY
button
Summary of Contents for XG-PH70X - XGA DLP Projector
Page 110: ...SHARP CORPORATION ...
