Lamp
unit
BQC-XGC55X//1
User service screw
Removing and Install-
ing the Lamp Unit
Info
•
Be sure to remove the lamp unit by the
handle. Be sure not to touch the glass
surface of the lamp unit or the inside of
the projector.
•
To avoid injury to yourself and damage
to the lamp, be sure to carefully follow
the steps below.
•
Do not loosen other screws except for the
lamp unit cover and lamp unit.
(Only the silver screws are loosened).
•
Please refer to the installation manual
included with the lamp unit.
1
Press
STANDBY
on the projector
or
on the remote control to
put the projector into the
standby mode.
•
Wait until the cooling fan stops.
Warning!
•
Do not remove the lamp unit from the
projector right after use. The lamp will
be very hot and may cause burn or
injury.
2
Disconnect the power cord.
•
Unplug the power cord from the AC
socket.
•
Leave the lamp until it has fully cooled
down (about 1 hour).
3
Change the air filter.
•
Change the air filter whenever you in-
stall the lamp unit (see pages
81
and
82
).
4
Remove the lamp unit cover.
•
Loosen the user service screw that
secures the lamp unit cover. Then
open the cover in the direction of the
arrow.
-86
Regarding the Lamp
AC socket
STANDBY button
STANDBY
button
Summary of Contents for XG-C55X - Conference Series XGA LCD Projector
