9
Dimensions: 257
⳯
182 mm
F L E ( M ) S d n . B h d .
V C - A 4 1 0 U / 4 2 0 U ( E ) ( 0 6 - 0 9 )
Connecting the VCR
The connection method differs depending on the type of TV.
If you have cable TV (CATV), see
Cable TV Connections
.
RF Connection (for connection to a TV without AV terminals)
!
Disconnect the TV antenna from the TV.
@
Connect the TV antenna cable to the ANTENNA IN terminal on the rear of the VCR.
#
Connect the TV OUT terminal on the rear of the VCR with the antenna terminal on the TV using a coaxial
cable. Select the TV channel 3 or 4 corresponding to the 3
↔
4 output channel selector of the VCR. (See
Setting the 3
↔
4 Output Channel Selector
below.)
AV Connection (for connection to a TV with AV terminals)
!
Disconnect the TV antenna from the TV.
@
Connect the antenna, VCR, and TV using the Audio/Video cable and coaxial cable (supplied) as shown.
#
Select the video input mode or A/V input mode on your TV. (See the
TV operation manual
for details.)
• If your VCR is a monaural model, connect the audio cable to “AUDIO OUT” on the VCR.
Coaxial cable
Antenna
ANTENNA IN
(antenna or
cable
input)
TV OUT
Coaxial cable (supplied)
Audio/Video
cable (not
supplied)
VCR Rear
(Hi-Fi model)
TV
Setting the 3
↔
4 Output Channel Selector
The 3
↔
4 OUTPUT CHANNEL selector changes the VCR OUTPUT to standard
TV broadcasting signals. Both your TV and VCR must be set to the same
channel (i.e. TV on channel 3 and VCR OUTPUT CHANNEL selector on 3).
Your VCR is set to channel 3 at the factory, so your TV should be tuned to
channel 3 as well. If channel 3 is an active broadcast channel in your area, set
the VCR 3
↔
4 OUTPUT CHANNEL selector to 4 and tune your TV to channel 4.
After the Connection
Plug in the power cord of the TV. Then go to
EZ Set Up
.
3
↔
4 OUTPUT CHANNEL
selector
Rear of Your VCR
Connect the flat twin lead cable
to a transformer
(300 ohm to 75 ohm, not
supplied)
Setting Up
Summary of Contents for VC-A410U
Page 37: ...37 Memo ...
