*
If an I/F (locally supplied half-size PC card) other than the ER-
A8RS is connected to the ISA bus connector, it may be required to
remove reinforcement angle
5
when inserting the I/F.
In this case, remove reinforcement angle
5
, insert the I/F, then
install reinforcement angle
5
.
15. SRN I/F: ER-01IN-PC
*
Adjust the IRQ10 and IRQ11.
(See the "13. Adjusting the IRQ10/11 on the ISA PWB.")
1) Remove the REAR COVER.
2) Remove the screw
1
from the ISA BUS SHASSIS.
3) Remove the OPTION ANGLE
2
.
4) Insert the I/F PWB
3
to the ISA BUS CONNECTOR.
5) Fix the I/F BRACKET and OPTION ANGLE
2
to the ISA BUS
SHASSIS with scew
1
.
*
Only one ER-01IN-PC can be installed.
6) Connect the SRN cable
5
to the I/F PWB.
16. REAR DISPLAY: ER-A8DP
1) Remove the rear cover.
2) Remove the panel
1
from the cover. And install the display filter
2
to the rear cover.
3) Connect the display cable
3
to the main PWB.
4) Install the Display PWB
4
to the cabinet.
a) Tilt the Display PWB (till the upper side) and insert it.
b) Hang the lower side of the Display PWB on the lower cabinet
pawls
A
(2 positions)
c) Engage the two pawls
B
of the Display PWB with the two
notches
C
in the chassis.
5
ER-01INPC connection
1
2
3
1
5
1
2
A
B
4
A
3
C
– 8 –