Cautions on handling connectors
When connecting or disconnecting the following connectors, follow
the procedures below.
1)
PARTS NAME
PARTS CODE
LOCATION
FFC
CONNECTOR
QCNCW7218RC3J
MAIN PWB: CN12
KEY I/F PWB: CN8/CN10
•
How to Connect or Disconnect FFC
(1)
Open the slider to unlock position
The slider will open only up to a fixed height (about 1.2mm). If
you forcibly pull up the slider further, it may be dropped.
(2)
Insert the FFC
Insert the FFC firmly untill the FFC hits the bottom of the con-
nector’s insulator.
(3)
Close the slider to lock position
Insert the FFC and then push the slider downward.
(4)
To pull out the FFC, unlock the slider to pull it out in the same
procedures as (1).
•
Replacement parts required when the OCNCW7218RC3J’s
slider is broken
Forcibly pulling up the slider further may cause the slider to
drop and to be broken in the worst case. You can change this
slider part only .
PARTS NAME
PARTS CODE
SLIDER
QCNCW7218RC00
2)
PARTS NAME
PARTS CODE
LOCATION
FFC
CONNECTOR
QCNCW7217RC3J
LCD RELAY
PWB: CN1
•
How to Insert FFC
(1)
Open the slider to unlock position
Open the slider upwards up to an angle of 60 degrees. If the
slider does not fully open, the FFC can not be smoothly inserted.
(2)
Insert the FFC
Insert the FFC firmly until the FFC hits the bottom of the connec-
tor’s insulator.
(3)
Close the slider to lock position
Insert the FFC and then push the slider downward.
(4)
To pull out the FFC, unlock the slider to pull it out in the same
procedures as (1).
Slider
1.2mm
UNLOCK
FFC
FFC
CONNECTOR
FFC
CONNECTOR
FFC
CONNECTOR
FFC
Slider
LOCK
FFC
FFC
CONNECTOR
FFC
CONNECTOR
FFC
CONNECTOR
FFC
FFC
– 2 –
