Sharp SW-120NC, Instruction Manual

Page: 64 / 111

4 ‐ 30
from scattering across the work tray. Adjust the width of the fence to be slightly larger
than the width of the bundle.
Step 7 – Press
Single/Bundle cutting mode button and switch to bundle cutting mode
.
Step 8 – For subsequent cutting procedures, refer to the instructions under manual operation and
automatic operation.
Uninstalling top clamp
Follow these steps to uninstall top clamp for cutting single material:
Step 1 – Disconnect the top clamp hoses.
Step 2 – Loosen the lock nuts and remove the top clamp.
Step 3 – Remove the stud bolts.
TERMINATING A CUTTING OPERATION
STOP

To terminate a cutting operation, press either the saw bow up button or the emergency stop
button.

The saw blade will stop running when the saw bow up button is pressed.

Both the saw blade and hydraulic pump motors will stop running when the emergency stop
button is pressed.

The machine will stop automatically when an error occurs. The error message will be shown on
the screen.