Note for assembly (1): Attach the paper feed roller so that the
one-way clutch in the rear frame side. (Be
careful to the installing direction.)
Attach the roller holder as shown below:
1-5. Resist roller
1
Insert a screwdriver into the front frame hole to release the lock
pawl, and remove the TC case.
2
Disengage the hook section of the bearing in the front frame side,
lift it upward and remove towards the upper frame side. Remove
the spring in the rear frame side. Disconnect the CN-E connector
in the lower frame PWB unit. Slide the resist roller ass’y to the rear
frame side and remove it upwards.
3
Remove the clutch, and the gear as shown below:
Note for assembly (1): When assembling, attach the positioning
pin of the resist roller clutch in the direc-
tion of paper exit.
Note for assembly (2): When assembling the resist roller ass’y to
the copier, attach it over the PS roller
lower mylar and rotate the mylar and
return the mylar to the original position.
(To prevent deformation of the mylar)
One-way clutch side
1
2
6 – 3
