5
INSTALLATION
3. The minimum height
of free space
necessary above
the top surface of
the oven is 19cm.
4. Do not place the
oven where heat, moisture or high humidity are
generated, (for example, near or above a
conventional oven) or near combustible
materials (for example, curtains). Do not block
or obstruct air vent openings. Do not place
objects on top of the oven.
5. Make sure the power supply cord is undamaged
(See “ELECTRICAL CONNECTION” below).
Do not allow the power supply cord
to run over any hot or sharp surfaces,
such as the hot air vent area at the
top rear of the oven.
6. The socket must be readily accessible so that
it can be easily unplugged in an emergency.
7. Do not use the oven outdoors.
BUILDING-IN-KIT.
This oven is designed for counter top or built-in use.
Do not place the oven in a cabinet.
An installation frame is available which enables
the microwave oven to be integrated within a
kitchen unit.
The microwave oven is not designed to be built
above or near a conventional oven.
SHARP recommend the use of the build in kit
EBR-5000
, available from your SHARP dealer.
Only the use of this frame will guarantee the
quality and safety of the oven.
ELECTRICAL CONNECTION.
• Do not allow water to come into contact with
the power supply cord or plug.
• Insert the plug properly into the socket.
• Do not connect other appliances to the same
socket using an adaptor plug.
• If the power supply cord is damaged, it must
be replaced by a SHARP approved service
facility or a similarly qualified person to avoid
a hazard.
• When removing the plug from the socket
always grip the plug, never the cord as this
may damage the power supply cord and the
connections inside the plug.
• If the plug fitted to your oven is a rewireable
type and in the event of the socket outlet
in your home not being compatible with the
plug supplied, remove the plug properly
(do not cut off).
• If the plug fitted to your oven is a non-rewirable
type and in the event of the socket outlet in
your home not being compatible with the plug
supplied, cut-off the mains plug.
• Refit with a suitable type, observing the wiring
code given in ‘To replace the mains plug’ on
page 38.
19cm
WARNING: THIS APPLIANCE MUST
BE EARTHED
To wire an appropriate plug, follow the wiring
code given in `To replace the mains plug’ on
page 38.
IMPORTANT!
• The fuse from the cut-off plug should be removed
and the plug disposed of in a safe manner.
• Under no circumstances should the cut-off plug
be inserted into a socket outlet as a serious
electric shock may occur.
• The plug must not be used without the fuse cover
fitted.
• If you have any doubt about your microwave
oven obtain the help of a qualified electrician.
• When replacing the plug please ensure that
you use a BSI or ASTA approved plug to
BS1363, this should be fitted with a brown
coloured 13 amp fuse approved by BSI or
ASTA to BS1362. If you have any doubt
about electrical connection seek the help of a
qualified electrician.
R-890SLM_EN.indd 5
R-890SLM_EN.indd 5
2/24/09 4:06:16 PM
2/24/09 4:06:16 PM
