30
XG-P10XE
No.
Adjusting point
Adjusting conditions
Adjusting procedure
1. Feed the 10 step signal to
G(Y) terminal of BNC termi-
nal.
2. Select the following subject.
Group : DVD
Subject : R1-GAIN
B1-GAIN
3. Connect the oscilloscope
toTP1101(R) and TP1201
(G)
4. Connect the oscilloscope
toTP1301(B) and TP1201
(G)
»
Choose R1-GAIN, and adjust so that the amplitude
of the R signal and the amplitude of the G signal
may become the same.
»
As for blue as well, adjust it in the same way.
27
DVD input
system panel
signal amplitude
adjustment
26
DVD Colour
1. Feed the colour bar signal
of the 480I component sig-
nal to the BNC G(Y) input
terminal.
2. Select the following subject.
Group : DVD
Subject : COLOR
3. Connect the oscilloscope to
pin (1) of P801.
»
Adjust the level difference between the 100% white
and red portions to 0.13 ±0.02 Vp-p.
100% White Red
29
Colour
irregularity
correction
position
1. Feed the gray-only RGB
colour signal. (XGA 60Hz)
2. Find the colour irregularity
position on the screen.
3. Group : NOKO
Subject : NOKO-RL
»
If the colour is irregular, adjust the NOKO-RL data.
Set it to R for the right-hand colour irregularity and
to L for the left-hand one.
»
If there is no colour irregularity, turn off the saw-
tooth correction using SW4201.
28
DVD White
balance
adjuustment
1. Feed the NTSC mono-
scope signal to G(Y) input
terminal of the BNC termi-
nal.
2. Select the following subject.
Group : DVD
Subject : R1-BLK
B1-BLK
»
Adjust so that a white balance may become the best
condition by using the control switch or buttons of
the R/C.
30
Colour
irregularity
correction gain
(in case of
colourirregularity)
1. Feed the gray-only RGB
colour signal. (XGA 60Hz)
»
Adjust R4215 to minimize the right-hand and left-
hand colour irregularity.
